linux/arch/xtensa/platforms/xtfpga/Makefile

# Makefile for the Tensilica xtavnet Emulation Board
#
# Note! Dependencies are done automagically by 'make dep', which also
# removes any old dependencies. DON'T put your own dependencies here
# unless it's something special (ie not a .c file).
#
# Note 2! The CFLAGS definitions are in the main makefile...

obj-y			+= setup.o
obj-$(CONFIG_XTFPGA_LCD) += lcd.o
xtensa: add support for the XTFPGA boards The Avnet LX60/LX110/LX200 board is an FPGA board that can be configured with an Xtensa processor and an OpenCores Ethernet device. Signed-off-by: Chris Zankel <chris@zankel.net> Signed-off-by: Max Filippov <jcmvbkbc@gmail.com> Signed-off-by: Chris Zankel <chris@zankel.net> 2012-11-05 07:37:14 +04:00			`# Makefile for the Tensilica xtavnet Emulation Board`
			`#`
			`# Note! Dependencies are done automagically by 'make dep', which also`
			`# removes any old dependencies. DON'T put your own dependencies here`
			`# unless it's something special (ie not a .c file).`
			`#`
			`# Note 2! The CFLAGS definitions are in the main makefile...`

xtensa: xtfpga: fix hardware lockup caused by LCD driver LCD driver is always built for the XTFPGA platform, but its base address is not configurable, and is wrong for ML605/KC705. Its initialization locks up KC705 board hardware. Make the whole driver optional, and its base address and bus width configurable. Implement 4-bit bus access method. Cc: stable@vger.kernel.org Signed-off-by: Max Filippov <jcmvbkbc@gmail.com> 2015-02-27 06:28:00 +03:00			`obj-y += setup.o`
			`obj-$(CONFIG_XTFPGA_LCD) += lcd.o`