linux/drivers/power/reset/Makefile

obj-$(CONFIG_POWER_RESET_GPIO) += gpio-poweroff.o
obj-$(CONFIG_POWER_RESET_QNAP) += qnap-poweroff.o
obj-$(CONFIG_POWER_RESET_RESTART) += restart-poweroff.o
power: Add simple poweroff-gpio driver Given appropriate devicetree bindings, this driver registers a pm_power_off function to set a GPIO line high/low to power down your board. Signed-off-by: Jamie Lentin <jm@lentin.co.uk> Signed-off-by: Andrew Lunn <andrew@lunn.ch> Tested-by:Simon Baatz <gmbnomis@gmail.com> Signed-off-by: Jason Cooper <jason@lakedaemon.net> 2012-11-17 09:51:04 +01:00			`obj-$(CONFIG_POWER_RESET_GPIO) += gpio-poweroff.o`
power/reset: Add a new driver to turn QNAP board power off The QNAP NAS boxes have a microcontroller attached to the SoCs second serial port. By sending it a simple command, it will turn the power for the board off. This driver registers a function for pm_power_off to send such a command. Signed-off-by: Andrew Lunn <andrew@lunn.ch> Signed-off-by: Anton Vorontsov <anton@enomsg.org> 2012-12-28 13:25:09 +01:00			`obj-$(CONFIG_POWER_RESET_QNAP) += qnap-poweroff.o`
power/reset: Add a new driver implementing 'power off by restarting' Some devices, Buffalo Linkstation LS-XHL and LS-CHLv2 for example, power-off by restarting to letting u-boot hold the SoC until the user presses a key. Add a generic driver to implement this. It binds a function to pm_power_off, which calls arm_pm_restart. Signed-off-by: Andrew Lunn <andrew@lunn.ch> Tested-by: Michael Walle <michael@walle.cc> Signed-off-by: Anton Vorontsov <anton@enomsg.org> 2012-12-28 13:25:11 +01:00			`obj-$(CONFIG_POWER_RESET_RESTART) += restart-poweroff.o`