diff --git a/drivers/usb/dwc3/core.c b/drivers/usb/dwc3/core.c
index 214a8ff2d69c..e581be9a76e2 100644
--- a/drivers/usb/dwc3/core.c
+++ b/drivers/usb/dwc3/core.c
@@ -277,46 +277,9 @@ int dwc3_core_soft_reset(struct dwc3 *dwc)
 	 * XHCI driver will reset the host block. If dwc3 was configured for
 	 * host-only mode or current role is host, then we can return early.
 	 */
-	if (dwc->current_dr_role == DWC3_GCTL_PRTCAP_HOST)
+	if (dwc->dr_mode == USB_DR_MODE_HOST || dwc->current_dr_role == DWC3_GCTL_PRTCAP_HOST)
 		return 0;
 
-	/*
-	 * If the dr_mode is host and the dwc->current_dr_role is not the
-	 * corresponding DWC3_GCTL_PRTCAP_HOST, then the dwc3_core_init_mode
-	 * isn't executed yet. Ensure the phy is ready before the controller
-	 * updates the GCTL.PRTCAPDIR or other settings by soft-resetting
-	 * the phy.
-	 *
-	 * Note: GUSB3PIPECTL[n] and GUSB2PHYCFG[n] are port settings where n
-	 * is port index. If this is a multiport host, then we need to reset
-	 * all active ports.
-	 */
-	if (dwc->dr_mode == USB_DR_MODE_HOST) {
-		u32 usb3_port;
-		u32 usb2_port;
-
-		usb3_port = dwc3_readl(dwc->regs, DWC3_GUSB3PIPECTL(0));
-		usb3_port |= DWC3_GUSB3PIPECTL_PHYSOFTRST;
-		dwc3_writel(dwc->regs, DWC3_GUSB3PIPECTL(0), usb3_port);
-
-		usb2_port = dwc3_readl(dwc->regs, DWC3_GUSB2PHYCFG(0));
-		usb2_port |= DWC3_GUSB2PHYCFG_PHYSOFTRST;
-		dwc3_writel(dwc->regs, DWC3_GUSB2PHYCFG(0), usb2_port);
-
-		/* Small delay for phy reset assertion */
-		usleep_range(1000, 2000);
-
-		usb3_port &= ~DWC3_GUSB3PIPECTL_PHYSOFTRST;
-		dwc3_writel(dwc->regs, DWC3_GUSB3PIPECTL(0), usb3_port);
-
-		usb2_port &= ~DWC3_GUSB2PHYCFG_PHYSOFTRST;
-		dwc3_writel(dwc->regs, DWC3_GUSB2PHYCFG(0), usb2_port);
-
-		/* Wait for clock synchronization */
-		msleep(50);
-		return 0;
-	}
-
 	reg = dwc3_readl(dwc->regs, DWC3_DCTL);
 	reg |= DWC3_DCTL_CSFTRST;
 	reg &= ~DWC3_DCTL_RUN_STOP;