x86/mce: Handle Intel threshold interrupt storms

Add an Intel specific hook into machine_check_poll() to keep track of
per-CPU, per-bank corrected error logs (with a stub for the
CONFIG_MCE_INTEL=n case).

When a storm is observed the rate of interrupts is reduced by setting
a large threshold value for this bank in IA32_MCi_CTL2. This bank is
added to the bitmap of banks for this CPU to poll. The polling rate is
increased to once per second.

When a storm ends reset the threshold in IA32_MCi_CTL2 back to 1, remove
the bank from the bitmap for polling, and change the polling rate back
to the default.

If a CPU with banks in storm mode is taken offline, the new CPU that
inherits ownership of those banks takes over management of storm(s) in
the inherited bank(s).

The cmci_discover() function was already very large. These changes
pushed it well over the top. Refactor with three helper functions to
bring it back under control.

Signed-off-by: Tony Luck <tony.luck@intel.com>
Signed-off-by: Borislav Petkov (AMD) <bp@alien8.de>
Link: https://lore.kernel.org/r/20231115195450.12963-4-tony.luck@intel.com

arch/x86/kernel/cpu/mce/intel.c

@@ -54,8 +54,27 @@ static DEFINE_RAW_SPINLOCK(cmci_discover_lock);
  */
 static DEFINE_SPINLOCK(cmci_poll_lock);
 
+/* Linux non-storm CMCI threshold (may be overridden by BIOS) */
 #define CMCI_THRESHOLD		1
 
+/*
+ * MCi_CTL2 threshold for each bank when there is no storm.
+ * Default value for each bank may have been set by BIOS.
+ */
+static u16 cmci_threshold[MAX_NR_BANKS];
+
+/*
+ * High threshold to limit CMCI rate during storms. Max supported is
+ * 0x7FFF. Use this slightly smaller value so it has a distinctive
+ * signature when some asks "Why am I not seeing all corrected errors?"
+ * A high threshold is used instead of just disabling CMCI for a
+ * bank because both corrected and uncorrected errors may be logged
+ * in the same bank and signalled with CMCI. The threshold only applies
+ * to corrected errors, so keeping CMCI enabled means that uncorrected
+ * errors will still be processed in a timely fashion.
+ */
+#define CMCI_STORM_THRESHOLD	32749
+
 static int cmci_supported(int *banks)
 {
 	u64 cap;
@@ -110,6 +129,31 @@ static bool lmce_supported(void)
 	return tmp & FEAT_CTL_LMCE_ENABLED;
 }
 
+/*
+ * Set a new CMCI threshold value. Preserve the state of the
+ * MCI_CTL2_CMCI_EN bit in case this happens during a
+ * cmci_rediscover() operation.
+ */
+static void cmci_set_threshold(int bank, int thresh)
+{
+	unsigned long flags;
+	u64 val;
+
+	raw_spin_lock_irqsave(&cmci_discover_lock, flags);
+	rdmsrl(MSR_IA32_MCx_CTL2(bank), val);
+	val &= ~MCI_CTL2_CMCI_THRESHOLD_MASK;
+	wrmsrl(MSR_IA32_MCx_CTL2(bank), val | thresh);
+	raw_spin_unlock_irqrestore(&cmci_discover_lock, flags);
+}
+
+void mce_intel_handle_storm(int bank, bool on)
+{
+	if (on)
+		cmci_set_threshold(bank, CMCI_STORM_THRESHOLD);
+	else
+		cmci_set_threshold(bank, cmci_threshold[bank]);
+}
+
 /*
  * The interrupt handler. This is called on every event.
  * Just call the poller directly to log any events.
@@ -121,72 +165,130 @@ static void intel_threshold_interrupt(void)
 	machine_check_poll(MCP_TIMESTAMP, this_cpu_ptr(&mce_banks_owned));
 }
 
+/*
+ * Check all the reasons why current CPU cannot claim
+ * ownership of a bank.
+ * 1: CPU already owns this bank
+ * 2: BIOS owns this bank
+ * 3: Some other CPU owns this bank
+ */
+static bool cmci_skip_bank(int bank, u64 *val)
+{
+	unsigned long *owned = (void *)this_cpu_ptr(&mce_banks_owned);
+
+	if (test_bit(bank, owned))
+		return true;
+
+	/* Skip banks in firmware first mode */
+	if (test_bit(bank, mce_banks_ce_disabled))
+		return true;
+
+	rdmsrl(MSR_IA32_MCx_CTL2(bank), *val);
+
+	/* Already owned by someone else? */
+	if (*val & MCI_CTL2_CMCI_EN) {
+		clear_bit(bank, owned);
+		__clear_bit(bank, this_cpu_ptr(mce_poll_banks));
+		return true;
+	}
+
+	return false;
+}
+
+/*
+ * Decide which CMCI interrupt threshold to use:
+ * 1: If this bank is in storm mode from whichever CPU was
+ *    the previous owner, stay in storm mode.
+ * 2: If ignoring any threshold set by BIOS, set Linux default
+ * 3: Try to honor BIOS threshold (unless buggy BIOS set it at zero).
+ */
+static u64 cmci_pick_threshold(u64 val, int *bios_zero_thresh)
+{
+	if ((val & MCI_CTL2_CMCI_THRESHOLD_MASK) == CMCI_STORM_THRESHOLD)
+		return val;
+
+	if (!mca_cfg.bios_cmci_threshold) {
+		val &= ~MCI_CTL2_CMCI_THRESHOLD_MASK;
+		val |= CMCI_THRESHOLD;
+	} else if (!(val & MCI_CTL2_CMCI_THRESHOLD_MASK)) {
+		/*
+		 * If bios_cmci_threshold boot option was specified
+		 * but the threshold is zero, we'll try to initialize
+		 * it to 1.
+		 */
+		*bios_zero_thresh = 1;
+		val |= CMCI_THRESHOLD;
+	}
+
+	return val;
+}
+
+/*
+ * Try to claim ownership of a bank.
+ */
+static void cmci_claim_bank(int bank, u64 val, int bios_zero_thresh, int *bios_wrong_thresh)
+{
+	struct mca_storm_desc *storm = this_cpu_ptr(&storm_desc);
+
+	val |= MCI_CTL2_CMCI_EN;
+	wrmsrl(MSR_IA32_MCx_CTL2(bank), val);
+	rdmsrl(MSR_IA32_MCx_CTL2(bank), val);
+
+	/* If the enable bit did not stick, this bank should be polled. */
+	if (!(val & MCI_CTL2_CMCI_EN)) {
+		WARN_ON(!test_bit(bank, this_cpu_ptr(mce_poll_banks)));
+		storm->banks[bank].poll_only = true;
+		return;
+	}
+
+	/* This CPU successfully set the enable bit. */
+	set_bit(bank, (void *)this_cpu_ptr(&mce_banks_owned));
+
+	if ((val & MCI_CTL2_CMCI_THRESHOLD_MASK) == CMCI_STORM_THRESHOLD) {
+		pr_notice("CPU%d BANK%d CMCI inherited storm\n", smp_processor_id(), bank);
+		mce_inherit_storm(bank);
+		cmci_storm_begin(bank);
+	} else {
+		__clear_bit(bank, this_cpu_ptr(mce_poll_banks));
+	}
+
+	/*
+	 * We are able to set thresholds for some banks that
+	 * had a threshold of 0. This means the BIOS has not
+	 * set the thresholds properly or does not work with
+	 * this boot option. Note down now and report later.
+	 */
+	if (mca_cfg.bios_cmci_threshold && bios_zero_thresh &&
+	    (val & MCI_CTL2_CMCI_THRESHOLD_MASK))
+		*bios_wrong_thresh = 1;
+
+	/* Save default threshold for each bank */
+	if (cmci_threshold[bank] == 0)
+		cmci_threshold[bank] = val & MCI_CTL2_CMCI_THRESHOLD_MASK;
+}
+
 /*
  * Enable CMCI (Corrected Machine Check Interrupt) for available MCE banks
  * on this CPU. Use the algorithm recommended in the SDM to discover shared
- * banks.
+ * banks. Called during initial bootstrap, and also for hotplug CPU operations
+ * to rediscover/reassign machine check banks.
  */
 static void cmci_discover(int banks)
 {
-	unsigned long *owned = (void *)this_cpu_ptr(&mce_banks_owned);
+	int bios_wrong_thresh = 0;
 	unsigned long flags;
 	int i;
-	int bios_wrong_thresh = 0;
 
 	raw_spin_lock_irqsave(&cmci_discover_lock, flags);
 	for (i = 0; i < banks; i++) {
 		u64 val;
 		int bios_zero_thresh = 0;
 
-		if (test_bit(i, owned))
+		if (cmci_skip_bank(i, &val))
 			continue;
 
-		/* Skip banks in firmware first mode */
+		val = cmci_pick_threshold(val, &bios_zero_thresh);
-		if (test_bit(i, mce_banks_ce_disabled))
+		cmci_claim_bank(i, val, bios_zero_thresh, &bios_wrong_thresh);
-			continue;
-
-		rdmsrl(MSR_IA32_MCx_CTL2(i), val);
-
-		/* Already owned by someone else? */
-		if (val & MCI_CTL2_CMCI_EN) {
-			clear_bit(i, owned);
-			__clear_bit(i, this_cpu_ptr(mce_poll_banks));
-			continue;
-		}
-
-		if (!mca_cfg.bios_cmci_threshold) {
-			val &= ~MCI_CTL2_CMCI_THRESHOLD_MASK;
-			val |= CMCI_THRESHOLD;
-		} else if (!(val & MCI_CTL2_CMCI_THRESHOLD_MASK)) {
-			/*
-			 * If bios_cmci_threshold boot option was specified
-			 * but the threshold is zero, we'll try to initialize
-			 * it to 1.
-			 */
-			bios_zero_thresh = 1;
-			val |= CMCI_THRESHOLD;
-		}
-
-		val |= MCI_CTL2_CMCI_EN;
-		wrmsrl(MSR_IA32_MCx_CTL2(i), val);
-		rdmsrl(MSR_IA32_MCx_CTL2(i), val);
-
-		/* Did the enable bit stick? -- the bank supports CMCI */
-		if (val & MCI_CTL2_CMCI_EN) {
-			set_bit(i, owned);
-			__clear_bit(i, this_cpu_ptr(mce_poll_banks));
-			/*
-			 * We are able to set thresholds for some banks that
-			 * had a threshold of 0. This means the BIOS has not
-			 * set the thresholds properly or does not work with
-			 * this boot option. Note down now and report later.
-			 */
-			if (mca_cfg.bios_cmci_threshold && bios_zero_thresh &&
-					(val & MCI_CTL2_CMCI_THRESHOLD_MASK))
-				bios_wrong_thresh = 1;
-		} else {
-			WARN_ON(!test_bit(i, this_cpu_ptr(mce_poll_banks)));
-		}
 	}
 	raw_spin_unlock_irqrestore(&cmci_discover_lock, flags);
 	if (mca_cfg.bios_cmci_threshold && bios_wrong_thresh) {
@@ -225,6 +327,9 @@ static void __cmci_disable_bank(int bank)
 	val &= ~MCI_CTL2_CMCI_EN;
 	wrmsrl(MSR_IA32_MCx_CTL2(bank), val);
 	__clear_bit(bank, this_cpu_ptr(mce_banks_owned));
+
+	if ((val & MCI_CTL2_CMCI_THRESHOLD_MASK) == CMCI_STORM_THRESHOLD)
+		cmci_storm_end(bank);
 }
 
 /*

arch/x86/kernel/cpu/mce/internal.h

@@ -41,6 +41,7 @@ struct dentry *mce_get_debugfs_dir(void);
 extern mce_banks_t mce_banks_ce_disabled;
 
 #ifdef CONFIG_X86_MCE_INTEL
+void mce_intel_handle_storm(int bank, bool on);
 void cmci_disable_bank(int bank);
 void intel_init_cmci(void);
 void intel_init_lmce(void);
@@ -48,6 +49,7 @@ void intel_clear_lmce(void);
 bool intel_filter_mce(struct mce *m);
 bool intel_mce_usable_address(struct mce *m);
 #else
+static inline void mce_intel_handle_storm(int bank, bool on) { }
 static inline void cmci_disable_bank(int bank) { }
 static inline void intel_init_cmci(void) { }
 static inline void intel_init_lmce(void) { }

arch/x86/kernel/cpu/mce/threshold.c

@@ -60,6 +60,9 @@ void mce_set_storm_mode(bool storm)
 static void mce_handle_storm(unsigned int bank, bool on)
 {
 	switch (boot_cpu_data.x86_vendor) {
+	case X86_VENDOR_INTEL:
+		mce_intel_handle_storm(bank, on);
+		break;
 	}
 }