From 30dc5873967ecc0282a8283622156cba4be8daf4 Mon Sep 17 00:00:00 2001 From: "Russell King (Oracle)" Date: Tue, 26 Mar 2024 14:32:12 +0100 Subject: [PATCH] net: phy: qcom: at803x: Avoid hibernating if MAC requires RX clock Stmmac controllers connected to an at803x PHY cannot resume properly after suspend when WoL is enabled. This happens because the MAC requires an RX clock generated by the PHY to initialize its hardware properly. But the RX clock is cut when the PHY suspends and isn't brought up until the MAC driver resumes the phylink. Prevent the at803x PHY driver from going into suspend if the attached MAC driver always requires an RX clock signal. Reported-by: Clark Wang Link: https://lore.kernel.org/all/20230202081559.3553637-1-xiaoning.wang@nxp.com/ Signed-off-by: Russell King (Oracle) [rgantois: commit log] Signed-off-by: Romain Gantois Reviewed-by: Andrew Lunn Link: https://lore.kernel.org/r/20240326-rxc_bugfix-v6-6-24a74e5c761f@bootlin.com Signed-off-by: Jakub Kicinski --- drivers/net/phy/qcom/at803x.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-) diff --git a/drivers/net/phy/qcom/at803x.c b/drivers/net/phy/qcom/at803x.c index e79657f76bea..c8f83e5f78ab 100644 --- a/drivers/net/phy/qcom/at803x.c +++ b/drivers/net/phy/qcom/at803x.c @@ -426,7 +426,8 @@ static int at803x_hibernation_mode_config(struct phy_device *phydev) /* The default after hardware reset is hibernation mode enabled. After * software reset, the value is retained. */ - if (!(priv->flags & AT803X_DISABLE_HIBERNATION_MODE)) + if (!(priv->flags & AT803X_DISABLE_HIBERNATION_MODE) && + !(phydev->dev_flags & PHY_F_RXC_ALWAYS_ON)) return 0; return at803x_debug_reg_mask(phydev, AT803X_DEBUG_REG_HIB_CTRL,