From 4b5047643466c3ef7ea71cc8c0f5d2dc2631d7ce Mon Sep 17 00:00:00 2001 From: Lucas Stach Date: Wed, 11 May 2022 18:08:23 +0200 Subject: [PATCH] ARM: dts: imx6qdl: correct PU regulator ramp delay commit 93a8ba2a619816d631bd69e9ce2172b4d7a481b8 upstream. Contrary to what was believed at the time, the ramp delay of 150us is not plenty for the PU LDO with the default step time of 512 pulses of the 24MHz clock. Measurements have shown that after enabling the LDO the voltage on VDDPU_CAP jumps to ~750mV in the first step and after that the regulator executes the normal ramp up as defined by the step size control. This means it takes the regulator between 360us and 370us to ramp up to the nominal 1.15V voltage for this power domain. With the old setting of the ramp delay the power up of the PU GPC domain would happen in the middle of the regulator ramp with the voltage being at around 900mV. Apparently this was enough for most units to properly power up the peripherals in the domain and execute the reset. Some units however, fail to power up properly, especially when the chip is at a low temperature. In that case any access to the GPU registers would yield an incorrect result with no way to recover from this situation. Change the ramp delay to 380us to cover the measured ramp up time with a bit of additional slack. Fixes: 40130d327f72 ("ARM: dts: imx6qdl: Allow disabling the PU regulator, add a enable ramp delay") Signed-off-by: Lucas Stach Signed-off-by: Shawn Guo Signed-off-by: Greg Kroah-Hartman --- arch/arm/boot/dts/imx6qdl.dtsi | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/arch/arm/boot/dts/imx6qdl.dtsi b/arch/arm/boot/dts/imx6qdl.dtsi index 89c342f3a7c2..8520ffc1779b 100644 --- a/arch/arm/boot/dts/imx6qdl.dtsi +++ b/arch/arm/boot/dts/imx6qdl.dtsi @@ -763,7 +763,7 @@ regulator-name = "vddpu"; regulator-min-microvolt = <725000>; regulator-max-microvolt = <1450000>; - regulator-enable-ramp-delay = <150>; + regulator-enable-ramp-delay = <380>; anatop-reg-offset = <0x140>; anatop-vol-bit-shift = <9>; anatop-vol-bit-width = <5>;