pinctrl: remove bindings for pinconf options needing more thought
Some options currently take arguments in unspecified driver-specific units. As pointed out by Stephen Warren, driver specific values should not be part of generic devicetree bindings describing the hardware. Therefore remove the critical bindings again, before they become part of an official release. Signed-off-by: Heiko Stuebner <heiko@sntech.de> Reviewed-by: James Hogan <james.hogan@imgtec.com> Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
This commit is contained in:
parent
a7b3bf55e7
commit
5b81d55c4c
@ -154,10 +154,7 @@ drive-open-source - drive with open source
|
||||
drive-strength - sink or source at most X mA
|
||||
input-schmitt-enable - enable schmitt-trigger mode
|
||||
input-schmitt-disable - disable schmitt-trigger mode
|
||||
input-schmitt - run in schmitt-trigger mode with hysteresis X
|
||||
input-debounce - debounce mode with debound time X
|
||||
power-source - select power source X
|
||||
slew-rate - use slew-rate X
|
||||
low-power-enable - enable low power mode
|
||||
low-power-disable - disable low power mode
|
||||
output-low - set the pin to output mode with low level
|
||||
@ -170,16 +167,9 @@ Arguments for parameters:
|
||||
|
||||
- drive-strength takes as argument the target strength in mA.
|
||||
|
||||
- input-schmitt takes as argument the adjustable hysteresis in a
|
||||
driver-specific format
|
||||
|
||||
- input-debounce takes the debounce time in usec as argument
|
||||
or 0 to disable debouncing
|
||||
|
||||
- power-source argument is the custom value describing the source to select
|
||||
|
||||
- slew-rate takes as argument the target rate in a driver-specific format
|
||||
|
||||
All parameters not listed here, do not take an argument.
|
||||
|
||||
More in-depth documentation on these parameters can be found in
|
||||
|
@ -161,10 +161,7 @@ static struct pinconf_generic_dt_params dt_params[] = {
|
||||
{ "drive-strength", PIN_CONFIG_DRIVE_STRENGTH, 0 },
|
||||
{ "input-schmitt-enable", PIN_CONFIG_INPUT_SCHMITT_ENABLE, 1 },
|
||||
{ "input-schmitt-disable", PIN_CONFIG_INPUT_SCHMITT_ENABLE, 0 },
|
||||
{ "input-schmitt", PIN_CONFIG_INPUT_SCHMITT, 0 },
|
||||
{ "input-debounce", PIN_CONFIG_INPUT_DEBOUNCE, 0 },
|
||||
{ "power-source", PIN_CONFIG_POWER_SOURCE, 0 },
|
||||
{ "slew-rate", PIN_CONFIG_SLEW_RATE, 0 },
|
||||
{ "low-power-enable", PIN_CONFIG_LOW_POWER_MODE, 1 },
|
||||
{ "low-power-disable", PIN_CONFIG_LOW_POWER_MODE, 0 },
|
||||
{ "output-low", PIN_CONFIG_OUTPUT, 0, },
|
||||
|
Loading…
Reference in New Issue
Block a user