iv/linux
1
0
Fork 0
Code Issues Pull Requests Actions Packages Projects Releases Wiki Activity

spi: qup: Add support for v1.1.1

Browse Source 
This patch adds support for v1.1.1 of the SPI QUP controller.

Signed-off-by: Andy Gross <agross@codeaurora.org>
Signed-off-by: Mark Brown <broonie@linaro.org>
This commit is contained in:
Andy Gross 2014-06-12 14:34:12 -05:00 committed by Mark Brown
parent 7171511eae
commit 70cea0a953
2 changed files with 27 additions and 15 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

6
Documentation/devicetree/bindings/spi/qcom,spi-qup.txt
View File

@ -7,7 +7,11 @@ SPI in master mode supports up to 50MHz, up to four chip selects, programmable
data path from 4 bits to 32 bits and numerous protocol variants.
Required properties:
- compatible: Should contain "qcom,spi-qup-v2.1.1" or "qcom,spi-qup-v2.2.1"
- compatible: Should contain:
"qcom,spi-qup-v1.1.1" for 8660, 8960 and 8064.
"qcom,spi-qup-v2.1.1" for 8974 and later
"qcom,spi-qup-v2.2.1" for 8974 v2 and later.
- reg: Should contain base register location and length
- interrupts: Interrupt number used by this controller

36
drivers/spi/spi-qup.c
View File

@ -142,6 +142,7 @@ struct spi_qup {
int w_size; /* bytes per SPI word */
int tx_bytes;
int rx_bytes;
int qup_v1;
};
@ -420,7 +421,9 @@ static int spi_qup_io_config(struct spi_device *spi, struct spi_transfer *xfer)
config |= QUP_CONFIG_SPI_MODE;
writel_relaxed(config, controller->base + QUP_CONFIG);
writel_relaxed(0, controller->base + QUP_OPERATIONAL_MASK);
/* only write to OPERATIONAL_MASK when register is present */
if (!controller->qup_v1)
writel_relaxed(0, controller->base + QUP_OPERATIONAL_MASK);
return 0;
}
@ -511,7 +514,7 @@ static int spi_qup_probe(struct platform_device *pdev)
struct resource *res;
struct device *dev;
void __iomem *base;
u32 data, max_freq, iomode;
u32 max_freq, iomode;
int ret, irq, size;
dev = &pdev->dev;
@ -554,15 +557,6 @@ static int spi_qup_probe(struct platform_device *pdev)
return ret;
}
data = readl_relaxed(base + QUP_HW_VERSION);
if (data < QUP_HW_VERSION_2_1_1) {
clk_disable_unprepare(cclk);
clk_disable_unprepare(iclk);
dev_err(dev, "v.%08x is not supported\n", data);
return -ENXIO;
}
master = spi_alloc_master(dev, sizeof(struct spi_qup));
if (!master) {
clk_disable_unprepare(cclk);
@ -591,6 +585,10 @@ static int spi_qup_probe(struct platform_device *pdev)
controller->cclk = cclk;
controller->irq = irq;
/* set v1 flag if device is version 1 */
if (of_device_is_compatible(dev->of_node, "qcom,spi-qup-v1.1.1"))
controller->qup_v1 = 1;
spin_lock_init(&controller->lock);
init_completion(&controller->done);
@ -614,8 +612,8 @@ static int spi_qup_probe(struct platform_device *pdev)
size = QUP_IO_M_INPUT_FIFO_SIZE(iomode);
controller->in_fifo_sz = controller->in_blk_sz * (2 << size);
dev_info(dev, "v.%08x IN:block:%d, fifo:%d, OUT:block:%d, fifo:%d\n",
data, controller->in_blk_sz, controller->in_fifo_sz,
dev_info(dev, "IN:block:%d, fifo:%d, OUT:block:%d, fifo:%d\n",
controller->in_blk_sz, controller->in_fifo_sz,
controller->out_blk_sz, controller->out_fifo_sz);
writel_relaxed(1, base + QUP_SW_RESET);
@ -628,10 +626,19 @@ static int spi_qup_probe(struct platform_device *pdev)
writel_relaxed(0, base + QUP_OPERATIONAL);
writel_relaxed(0, base + QUP_IO_M_MODES);
writel_relaxed(0, base + QUP_OPERATIONAL_MASK);
if (!controller->qup_v1)
writel_relaxed(0, base + QUP_OPERATIONAL_MASK);
writel_relaxed(SPI_ERROR_CLK_UNDER_RUN | SPI_ERROR_CLK_OVER_RUN,
base + SPI_ERROR_FLAGS_EN);
/* if earlier version of the QUP, disable INPUT_OVERRUN */
if (controller->qup_v1)
writel_relaxed(QUP_ERROR_OUTPUT_OVER_RUN |
QUP_ERROR_INPUT_UNDER_RUN | QUP_ERROR_OUTPUT_UNDER_RUN,
base + QUP_ERROR_FLAGS_EN);
writel_relaxed(0, base + SPI_CONFIG);
writel_relaxed(SPI_IO_C_NO_TRI_STATE, base + SPI_IO_CONTROL);
@ -750,6 +757,7 @@ static int spi_qup_remove(struct platform_device *pdev)
}
static const struct of_device_id spi_qup_dt_match[] = {
{ .compatible = "qcom,spi-qup-v1.1.1", },
{ .compatible = "qcom,spi-qup-v2.1.1", },
{ .compatible = "qcom,spi-qup-v2.2.1", },
{ }