ath6kl: add ATH6KL_CONF_UART_DEBUG
Add ATH6KL_CONF_UART_DEBUG which is set whenever uart_debug module parameter is enabled. This way we can keep the uart_debug parameter static when core.c file is introduced. Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
This commit is contained in:
parent
46d33a21cf
commit
f29af97853
@ -197,6 +197,7 @@ struct ath6kl_fw_ie {
|
||||
#define ATH6KL_CONF_ENABLE_11N BIT(2)
|
||||
#define ATH6KL_CONF_ENABLE_TX_BURST BIT(3)
|
||||
#define ATH6KL_CONF_SUSPEND_CUTPOWER BIT(4)
|
||||
#define ATH6KL_CONF_UART_DEBUG BIT(5)
|
||||
|
||||
enum wlan_low_pwr_state {
|
||||
WLAN_POWER_STATE_ON,
|
||||
|
@ -469,7 +469,7 @@ int ath6kl_configure_target(struct ath6kl *ar)
|
||||
u8 fw_iftype, fw_mode = 0, fw_submode = 0;
|
||||
int i, status;
|
||||
|
||||
param = uart_debug;
|
||||
param = !!(ar->conf_flags & ATH6KL_CONF_UART_DEBUG);
|
||||
if (ath6kl_bmi_write(ar, ath6kl_get_hi_item_addr(ar,
|
||||
HI_ITEM(hi_serial_enable)), (u8 *)¶m, 4)) {
|
||||
ath6kl_err("bmi_write_memory for uart debug failed\n");
|
||||
@ -1775,6 +1775,9 @@ int ath6kl_core_init(struct ath6kl *ar)
|
||||
if (suspend_cutpower)
|
||||
ar->conf_flags |= ATH6KL_CONF_SUSPEND_CUTPOWER;
|
||||
|
||||
if (uart_debug)
|
||||
ar->conf_flags |= ATH6KL_CONF_UART_DEBUG;
|
||||
|
||||
ar->wiphy->flags |= WIPHY_FLAG_SUPPORTS_FW_ROAM |
|
||||
WIPHY_FLAG_HAVE_AP_SME |
|
||||
WIPHY_FLAG_HAS_REMAIN_ON_CHANNEL |
|
||||
|
Loading…
x
Reference in New Issue
Block a user