IF YOU WOULD LIKE TO GET AN ACCOUNT, please write an
email to Administrator. User accounts are meant only to access repo
and report issues and/or generate pull requests.
This is a purpose-specific Git hosting for
BaseALT
projects. Thank you for your understanding!
Только зарегистрированные пользователи имеют доступ к сервису!
Для получения аккаунта, обратитесь к администратору.
Align with hardware recommended sequences, and read all IPC registers
before doing any other actions. Playing with BUSY and DONE bits may
invalidate values.
The values read may not actually be necessary but at least this
provides a snapshot of the IPC registers with no consistency issues.
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
We use shim registers only to notify the other
side that a message was sent. The actual information
for the message is transmitted via mailbox.
cmd information inside shim register is not used by
the DSP, so we remove it to avoid confusion.
Signed-off-by: Daniel Baluta <daniel.baluta@gmail.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
Currently on all supported platforms the IPC IRQ thread first signals
the sender when an IPC response is received from the DSP, then unmasks
the IPC interrupt. Those actions are performed without holding any
locks, so the thread can be interrupted between them. IPC timeouts
have been observed in such scenarios: if the sender is woken up and it
proceeds with sending the next message without unmasking the IPC
interrupt, it can miss the next response. This patch takes a spin-lock
to prevent the IRQ thread from being preempted at that point. It also
makes sure, that the next IPC transmission by the host cannot take
place before the IRQ thread has finished updating all the required IPC
registers.
Fixes: 53e0c72d98b ("ASoC: SOF: Add support for IPC IO between DSP and Host")
Reviewed-by: Takashi Iwai <tiwai@suse.de>
Signed-off-by: Guennadi Liakhovetski <guennadi.liakhovetski@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
When using a shared IRQ between IPC interrupt and stream IOC interrupt,
the interrupt handlers need to check the interrupt source before
scheduling their respective IRQ threads. In the case of IPC handler, it
should check if it is an IPC interrupt before waking up the IPC IRQ
thread.
The IPC IRQ thread, once scheduled, does not need to check the IRQ
source again. So, remove the superfluous check in the thread. Remove the
irq_status field from snd_sof_dev struct also as it is no longer needed.
Signed-off-by: Keyon Jie <yang.jie@linux.intel.com>
Signed-off-by: Pierre-Louis Bossart <pierre-louis.bossart@linux.intel.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
