11f1ceca70
This patch introduces a new API to get requirements and configure the interconnect buses across the entire chipset to fit with the current demand. The API is using a consumer/provider-based model, where the providers are the interconnect buses and the consumers could be various drivers. The consumers request interconnect resources (path) between endpoints and set the desired constraints on this data flow path. The providers receive requests from consumers and aggregate these requests for all master-slave pairs on that path. Then the providers configure each node along the path to support a bandwidth that satisfies all bandwidth requests that cross through that node. The topology could be complicated and multi-tiered and is SoC specific. Reviewed-by: Evan Green <evgreen@chromium.org> Signed-off-by: Georgi Djakov <georgi.djakov@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
190 lines
5.3 KiB
Makefile
190 lines
5.3 KiB
Makefile
# SPDX-License-Identifier: GPL-2.0
|
|
#
|
|
# Makefile for the Linux kernel device drivers.
|
|
#
|
|
# 15 Sep 2000, Christoph Hellwig <hch@infradead.org>
|
|
# Rewritten to use lists instead of if-statements.
|
|
#
|
|
|
|
obj-y += irqchip/
|
|
obj-y += bus/
|
|
|
|
obj-$(CONFIG_GENERIC_PHY) += phy/
|
|
|
|
# GPIO must come after pinctrl as gpios may need to mux pins etc
|
|
obj-$(CONFIG_PINCTRL) += pinctrl/
|
|
obj-$(CONFIG_GPIOLIB) += gpio/
|
|
obj-y += pwm/
|
|
|
|
obj-y += pci/
|
|
|
|
obj-$(CONFIG_PARISC) += parisc/
|
|
obj-$(CONFIG_RAPIDIO) += rapidio/
|
|
obj-y += video/
|
|
obj-y += idle/
|
|
|
|
# IPMI must come before ACPI in order to provide IPMI opregion support
|
|
obj-y += char/ipmi/
|
|
|
|
obj-$(CONFIG_ACPI) += acpi/
|
|
obj-$(CONFIG_SFI) += sfi/
|
|
# PnP must come after ACPI since it will eventually need to check if acpi
|
|
# was used and do nothing if so
|
|
obj-$(CONFIG_PNP) += pnp/
|
|
obj-y += amba/
|
|
|
|
obj-y += clk/
|
|
# Many drivers will want to use DMA so this has to be made available
|
|
# really early.
|
|
obj-$(CONFIG_DMADEVICES) += dma/
|
|
|
|
# SOC specific infrastructure drivers.
|
|
obj-y += soc/
|
|
|
|
obj-$(CONFIG_VIRTIO) += virtio/
|
|
obj-$(CONFIG_XEN) += xen/
|
|
|
|
# regulators early, since some subsystems rely on them to initialize
|
|
obj-$(CONFIG_REGULATOR) += regulator/
|
|
|
|
# reset controllers early, since gpu drivers might rely on them to initialize
|
|
obj-$(CONFIG_RESET_CONTROLLER) += reset/
|
|
|
|
# tty/ comes before char/ so that the VT console is the boot-time
|
|
# default.
|
|
obj-y += tty/
|
|
obj-y += char/
|
|
|
|
# iommu/ comes before gpu as gpu are using iommu controllers
|
|
obj-$(CONFIG_IOMMU_SUPPORT) += iommu/
|
|
|
|
# gpu/ comes after char for AGP vs DRM startup and after iommu
|
|
obj-y += gpu/
|
|
|
|
obj-$(CONFIG_CONNECTOR) += connector/
|
|
|
|
# i810fb and intelfb depend on char/agp/
|
|
obj-$(CONFIG_FB_I810) += video/fbdev/i810/
|
|
obj-$(CONFIG_FB_INTEL) += video/fbdev/intelfb/
|
|
|
|
obj-$(CONFIG_PARPORT) += parport/
|
|
obj-$(CONFIG_NVM) += lightnvm/
|
|
obj-y += base/ block/ misc/ mfd/ nfc/
|
|
obj-$(CONFIG_LIBNVDIMM) += nvdimm/
|
|
obj-$(CONFIG_DAX) += dax/
|
|
obj-$(CONFIG_DMA_SHARED_BUFFER) += dma-buf/
|
|
obj-$(CONFIG_NUBUS) += nubus/
|
|
obj-y += macintosh/
|
|
obj-$(CONFIG_IDE) += ide/
|
|
obj-y += scsi/
|
|
obj-y += nvme/
|
|
obj-$(CONFIG_ATA) += ata/
|
|
obj-$(CONFIG_TARGET_CORE) += target/
|
|
obj-$(CONFIG_MTD) += mtd/
|
|
obj-$(CONFIG_SPI) += spi/
|
|
obj-$(CONFIG_SPMI) += spmi/
|
|
obj-$(CONFIG_HSI) += hsi/
|
|
obj-$(CONFIG_SLIMBUS) += slimbus/
|
|
obj-y += net/
|
|
obj-$(CONFIG_ATM) += atm/
|
|
obj-$(CONFIG_FUSION) += message/
|
|
obj-y += firewire/
|
|
obj-$(CONFIG_UIO) += uio/
|
|
obj-$(CONFIG_VFIO) += vfio/
|
|
obj-y += cdrom/
|
|
obj-y += auxdisplay/
|
|
obj-$(CONFIG_PCCARD) += pcmcia/
|
|
obj-$(CONFIG_DIO) += dio/
|
|
obj-$(CONFIG_SBUS) += sbus/
|
|
obj-$(CONFIG_ZORRO) += zorro/
|
|
obj-$(CONFIG_ATA_OVER_ETH) += block/aoe/
|
|
obj-$(CONFIG_PARIDE) += block/paride/
|
|
obj-$(CONFIG_TC) += tc/
|
|
obj-$(CONFIG_UWB) += uwb/
|
|
obj-$(CONFIG_USB_PHY) += usb/
|
|
obj-$(CONFIG_USB) += usb/
|
|
obj-$(CONFIG_USB_SUPPORT) += usb/
|
|
obj-$(CONFIG_PCI) += usb/
|
|
obj-$(CONFIG_USB_GADGET) += usb/
|
|
obj-$(CONFIG_OF) += usb/
|
|
obj-$(CONFIG_SERIO) += input/serio/
|
|
obj-$(CONFIG_GAMEPORT) += input/gameport/
|
|
obj-$(CONFIG_INPUT) += input/
|
|
obj-$(CONFIG_RTC_LIB) += rtc/
|
|
obj-y += i2c/ i3c/ media/
|
|
obj-$(CONFIG_PPS) += pps/
|
|
obj-y += ptp/
|
|
obj-$(CONFIG_W1) += w1/
|
|
obj-y += power/
|
|
obj-$(CONFIG_HWMON) += hwmon/
|
|
obj-$(CONFIG_THERMAL) += thermal/
|
|
obj-$(CONFIG_WATCHDOG) += watchdog/
|
|
obj-$(CONFIG_MD) += md/
|
|
obj-$(CONFIG_BT) += bluetooth/
|
|
obj-$(CONFIG_ACCESSIBILITY) += accessibility/
|
|
obj-$(CONFIG_ISDN) += isdn/
|
|
obj-$(CONFIG_EDAC) += edac/
|
|
obj-$(CONFIG_EISA) += eisa/
|
|
obj-$(CONFIG_PM_OPP) += opp/
|
|
obj-$(CONFIG_CPU_FREQ) += cpufreq/
|
|
obj-$(CONFIG_CPU_IDLE) += cpuidle/
|
|
obj-y += mmc/
|
|
obj-$(CONFIG_MEMSTICK) += memstick/
|
|
obj-$(CONFIG_NEW_LEDS) += leds/
|
|
obj-$(CONFIG_INFINIBAND) += infiniband/
|
|
obj-$(CONFIG_SGI_SN) += sn/
|
|
obj-y += firmware/
|
|
obj-$(CONFIG_CRYPTO) += crypto/
|
|
obj-$(CONFIG_SUPERH) += sh/
|
|
ifndef CONFIG_ARCH_USES_GETTIMEOFFSET
|
|
obj-y += clocksource/
|
|
endif
|
|
obj-$(CONFIG_DCA) += dca/
|
|
obj-$(CONFIG_HID) += hid/
|
|
obj-$(CONFIG_PPC_PS3) += ps3/
|
|
obj-$(CONFIG_OF) += of/
|
|
obj-$(CONFIG_SSB) += ssb/
|
|
obj-$(CONFIG_BCMA) += bcma/
|
|
obj-$(CONFIG_VHOST_RING) += vhost/
|
|
obj-$(CONFIG_VHOST) += vhost/
|
|
obj-$(CONFIG_VLYNQ) += vlynq/
|
|
obj-$(CONFIG_STAGING) += staging/
|
|
obj-y += platform/
|
|
|
|
obj-$(CONFIG_MAILBOX) += mailbox/
|
|
obj-$(CONFIG_HWSPINLOCK) += hwspinlock/
|
|
obj-$(CONFIG_REMOTEPROC) += remoteproc/
|
|
obj-$(CONFIG_RPMSG) += rpmsg/
|
|
obj-$(CONFIG_SOUNDWIRE) += soundwire/
|
|
|
|
# Virtualization drivers
|
|
obj-$(CONFIG_VIRT_DRIVERS) += virt/
|
|
obj-$(CONFIG_HYPERV) += hv/
|
|
|
|
obj-$(CONFIG_PM_DEVFREQ) += devfreq/
|
|
obj-$(CONFIG_EXTCON) += extcon/
|
|
obj-$(CONFIG_MEMORY) += memory/
|
|
obj-$(CONFIG_IIO) += iio/
|
|
obj-$(CONFIG_VME_BUS) += vme/
|
|
obj-$(CONFIG_IPACK_BUS) += ipack/
|
|
obj-$(CONFIG_NTB) += ntb/
|
|
obj-$(CONFIG_FMC) += fmc/
|
|
obj-$(CONFIG_POWERCAP) += powercap/
|
|
obj-$(CONFIG_MCB) += mcb/
|
|
obj-$(CONFIG_PERF_EVENTS) += perf/
|
|
obj-$(CONFIG_RAS) += ras/
|
|
obj-$(CONFIG_THUNDERBOLT) += thunderbolt/
|
|
obj-$(CONFIG_CORESIGHT) += hwtracing/coresight/
|
|
obj-y += hwtracing/intel_th/
|
|
obj-$(CONFIG_STM) += hwtracing/stm/
|
|
obj-$(CONFIG_ANDROID) += android/
|
|
obj-$(CONFIG_NVMEM) += nvmem/
|
|
obj-$(CONFIG_FPGA) += fpga/
|
|
obj-$(CONFIG_FSI) += fsi/
|
|
obj-$(CONFIG_TEE) += tee/
|
|
obj-$(CONFIG_MULTIPLEXER) += mux/
|
|
obj-$(CONFIG_UNISYS_VISORBUS) += visorbus/
|
|
obj-$(CONFIG_SIOX) += siox/
|
|
obj-$(CONFIG_GNSS) += gnss/
|
|
obj-$(CONFIG_INTERCONNECT) += interconnect/
|