7dc11169a0
Most of SoC device trees do not provide the thermal_zones label. Thus
stop depending on it and use the full path to the thermal zones nodes.
Fixes: 7a3544e5d4e8 ("arm64: dts: qcom: pmr735a: Add temp-alarm support")
Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@linaro.org>
Signed-off-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Link: https://lore.kernel.org/r/20220226205035.1826360-6-dmitry.baryshkov@linaro.org
58 lines
1.1 KiB
Plaintext
58 lines
1.1 KiB
Plaintext
// SPDX-License-Identifier: BSD-3-Clause
|
|
/*
|
|
* Copyright (c) 2021, Linaro Limited
|
|
*/
|
|
|
|
#include <dt-bindings/interrupt-controller/irq.h>
|
|
#include <dt-bindings/spmi/spmi.h>
|
|
|
|
&spmi_bus {
|
|
pmr735a: pmic@4 {
|
|
compatible = "qcom,pmr735a", "qcom,spmi-pmic";
|
|
reg = <0x4 SPMI_USID>;
|
|
#address-cells = <1>;
|
|
#size-cells = <0>;
|
|
|
|
pmr735a_temp_alarm: temp-alarm@a00 {
|
|
compatible = "qcom,spmi-temp-alarm";
|
|
reg = <0xa00>;
|
|
interrupts = <0x4 0xa 0x0 IRQ_TYPE_EDGE_BOTH>;
|
|
#thermal-sensor-cells = <0>;
|
|
};
|
|
|
|
pmr735a_gpios: gpio@8800 {
|
|
compatible = "qcom,pmr735a-gpio", "qcom,spmi-gpio";
|
|
reg = <0x8800>;
|
|
gpio-controller;
|
|
gpio-ranges = <&pmr735a_gpios 0 0 4>;
|
|
#gpio-cells = <2>;
|
|
interrupt-controller;
|
|
#interrupt-cells = <2>;
|
|
};
|
|
};
|
|
};
|
|
|
|
/ {
|
|
thermal-zones {
|
|
pmr735a_thermal: pmr735a-thermal {
|
|
polling-delay-passive = <100>;
|
|
polling-delay = <0>;
|
|
thermal-sensors = <&pmr735a_temp_alarm>;
|
|
|
|
trips {
|
|
pmr735a_trip0: trip0 {
|
|
temperature = <95000>;
|
|
hysteresis = <0>;
|
|
type = "passive";
|
|
};
|
|
|
|
pmr735a_crit: pmr735a-crit {
|
|
temperature = <115000>;
|
|
hysteresis = <0>;
|
|
type = "critical";
|
|
};
|
|
};
|
|
};
|
|
};
|
|
};
|