f861a9253e
Expand the description of the 'gpios' property in the GPIO assisted NAND flash binding, to explicitly list the required GPIO pin references and their order. Update the example section to individually bracket the GPIO references, and capitalize the signal names for improved readability. Signed-off-by: Gerhard Sittig <gsi@denx.de> Signed-off-by: Brian Norris <computersforpeace@gmail.com>
48 lines
1.6 KiB
Plaintext
48 lines
1.6 KiB
Plaintext
GPIO assisted NAND flash
|
|
|
|
The GPIO assisted NAND flash uses a memory mapped interface to
|
|
read/write the NAND commands and data and GPIO pins for the control
|
|
signals.
|
|
|
|
Required properties:
|
|
- compatible : "gpio-control-nand"
|
|
- reg : should specify localbus chip select and size used for the chip. The
|
|
resource describes the data bus connected to the NAND flash and all accesses
|
|
are made in native endianness.
|
|
- #address-cells, #size-cells : Must be present if the device has sub-nodes
|
|
representing partitions.
|
|
- gpios : Specifies the GPIO pins to control the NAND device. The order of
|
|
GPIO references is: RDY, nCE, ALE, CLE, and an optional nWP.
|
|
|
|
Optional properties:
|
|
- bank-width : Width (in bytes) of the device. If not present, the width
|
|
defaults to 1 byte.
|
|
- chip-delay : chip dependent delay for transferring data from array to
|
|
read registers (tR). If not present then a default of 20us is used.
|
|
- gpio-control-nand,io-sync-reg : A 64-bit physical address for a read
|
|
location used to guard against bus reordering with regards to accesses to
|
|
the GPIO's and the NAND flash data bus. If present, then after changing
|
|
GPIO state and before and after command byte writes, this register will be
|
|
read to ensure that the GPIO accesses have completed.
|
|
|
|
The device tree may optionally contain sub-nodes describing partitions of the
|
|
address space. See partition.txt for more detail.
|
|
|
|
Examples:
|
|
|
|
gpio-nand@1,0 {
|
|
compatible = "gpio-control-nand";
|
|
reg = <1 0x0000 0x2>;
|
|
#address-cells = <1>;
|
|
#size-cells = <1>;
|
|
gpios = <&banka 1 0>, /* RDY */
|
|
<&banka 2 0>, /* nCE */
|
|
<&banka 3 0>, /* ALE */
|
|
<&banka 4 0>, /* CLE */
|
|
<0>; /* nWP */
|
|
|
|
partition@0 {
|
|
...
|
|
};
|
|
};
|