Ravi Bangoria 29da4f91c0 powerpc/watchpoint: Don't allow concurrent perf and ptrace events
With Book3s DAWR, ptrace and perf watchpoints on powerpc behaves
differently. Ptrace watchpoint works in one-shot mode and generates
signal before executing instruction. It's ptrace user's job to
single-step the instruction and re-enable the watchpoint. OTOH, in
case of perf watchpoint, kernel emulates/single-steps the instruction
and then generates event. If perf and ptrace creates two events with
same or overlapping address ranges, it's ambiguous to decide who
should single-step the instruction. Because of this issue, don't
allow perf and ptrace watchpoint at the same time if their address
range overlaps.

Signed-off-by: Ravi Bangoria <ravi.bangoria@linux.ibm.com>
Signed-off-by: Michael Ellerman <mpe@ellerman.id.au>
Reviewed-by: Michael Neuling <mikey@neuling.org>
Link: https://lore.kernel.org/r/20200514111741.97993-15-ravi.bangoria@linux.ibm.com
2020-05-19 00:14:45 +10:00
..
2020-04-03 13:12:26 -07:00
2019-11-27 11:42:01 -08:00
2019-12-18 18:07:31 +01:00
\n
2020-04-06 08:58:42 -07:00
2020-03-31 15:04:17 -07:00
2020-03-30 18:06:39 -07:00
2020-03-21 16:00:24 +01:00
2019-12-04 19:44:14 -08:00
2020-01-08 16:32:55 +00:00
2020-04-09 12:52:34 -07:00
2020-03-21 18:56:06 -07:00
2020-01-14 12:20:48 +01:00
2019-12-04 15:18:39 +01:00
2020-03-30 18:06:39 -07:00
2019-12-18 18:07:31 +01:00
2019-07-08 19:36:47 -07:00
2019-07-08 19:36:47 -07:00