405329fc9a
Normally guests will set up CR3 themselves, but some guests, such as kselftests, and potentially CONFIG_PVH guests, rely on being booted with paging enabled and CR3 initialized to a pre-allocated page table. Currently CR3 updates via KVM_SET_SREGS* are not loaded into the guest VMCB until just prior to entering the guest. For SEV-ES/SEV-SNP, this is too late, since it will have switched over to using the VMSA page prior to that point, with the VMSA CR3 copied from the VMCB initial CR3 value: 0. Address this by sync'ing the CR3 value into the VMCB save area immediately when KVM_SET_SREGS* is issued so it will find it's way into the initial VMSA. Suggested-by: Tom Lendacky <thomas.lendacky@amd.com> Signed-off-by: Michael Roth <michael.roth@amd.com> Message-Id: <20211216171358.61140-10-michael.roth@amd.com> [Remove vmx_post_set_cr3; add a remark about kvm_set_cr3 not calling the new hook. - Paolo] Signed-off-by: Paolo Bonzini <pbonzini@redhat.com> |
||
|---|---|---|
| .. | ||
| boot | ||
| configs | ||
| crypto | ||
| entry | ||
| events | ||
| hyperv | ||
| ia32 | ||
| include | ||
| kernel | ||
| kvm | ||
| lib | ||
| math-emu | ||
| mm | ||
| net | ||
| pci | ||
| platform | ||
| power | ||
| purgatory | ||
| ras | ||
| realmode | ||
| tools | ||
| um | ||
| video | ||
| xen | ||
| .gitignore | ||
| Kbuild | ||
| Kconfig | ||
| Kconfig.assembler | ||
| Kconfig.cpu | ||
| Kconfig.debug | ||
| Makefile | ||
| Makefile_32.cpu | ||
| Makefile.um | ||