d8c7983f31
Add registers and bits definitions for SAMA7G5's UDDRC and DDR3PHY. Signed-off-by: Claudiu Beznea <claudiu.beznea@microchip.com> Signed-off-by: Nicolas Ferre <nicolas.ferre@microchip.com> Link: https://lore.kernel.org/r/20210415105010.569620-12-claudiu.beznea@microchip.com
81 lines
3.9 KiB
C
81 lines
3.9 KiB
C
/* SPDX-License-Identifier: GPL-2.0-only */
|
|
/*
|
|
* Microchip SAMA7 UDDR Controller and DDR3 PHY Controller registers offsets
|
|
* and bit definitions.
|
|
*
|
|
* Copyright (C) [2020] Microchip Technology Inc. and its subsidiaries
|
|
*
|
|
* Author: Claudu Beznea <claudiu.beznea@microchip.com>
|
|
*/
|
|
|
|
#ifndef __SAMA7_DDR_H__
|
|
#define __SAMA7_DDR_H__
|
|
|
|
#ifdef CONFIG_SOC_SAMA7
|
|
|
|
/* DDR3PHY */
|
|
#define DDR3PHY_PIR (0x04) /* DDR3PHY PHY Initialization Register */
|
|
#define DDR3PHY_PIR_DLLBYP (1 << 17) /* DLL Bypass */
|
|
#define DDR3PHY_PIR_ITMSRST (1 << 4) /* Interface Timing Module Soft Reset */
|
|
#define DDR3PHY_PIR_DLLLOCK (1 << 2) /* DLL Lock */
|
|
#define DDR3PHY_PIR_DLLSRST (1 << 1) /* DLL Soft Rest */
|
|
#define DDR3PHY_PIR_INIT (1 << 0) /* Initialization Trigger */
|
|
|
|
#define DDR3PHY_PGCR (0x08) /* DDR3PHY PHY General Configuration Register */
|
|
#define DDR3PHY_PGCR_CKDV1 (1 << 13) /* CK# Disable Value */
|
|
#define DDR3PHY_PGCR_CKDV0 (1 << 12) /* CK Disable Value */
|
|
|
|
#define DDR3PHY_PGSR (0x0C) /* DDR3PHY PHY General Status Register */
|
|
#define DDR3PHY_PGSR_IDONE (1 << 0) /* Initialization Done */
|
|
|
|
#define DDR3PHY_ACIOCR (0x24) /* DDR3PHY AC I/O Configuration Register */
|
|
#define DDR3PHY_ACIOCR_CSPDD_CS0 (1 << 18) /* CS#[0] Power Down Driver */
|
|
#define DDR3PHY_ACIOCR_CKPDD_CK0 (1 << 8) /* CK[0] Power Down Driver */
|
|
#define DDR3PHY_ACIORC_ACPDD (1 << 3) /* AC Power Down Driver */
|
|
|
|
#define DDR3PHY_DXCCR (0x28) /* DDR3PHY DATX8 Common Configuration Register */
|
|
#define DDR3PHY_DXCCR_DXPDR (1 << 3) /* Data Power Down Receiver */
|
|
|
|
#define DDR3PHY_DSGCR (0x2C) /* DDR3PHY DDR System General Configuration Register */
|
|
#define DDR3PHY_DSGCR_ODTPDD_ODT0 (1 << 20) /* ODT[0] Power Down Driver */
|
|
|
|
#define DDR3PHY_ZQ0SR0 (0x188) /* ZQ status register 0 */
|
|
|
|
/* UDDRC */
|
|
#define UDDRC_STAT (0x04) /* UDDRC Operating Mode Status Register */
|
|
#define UDDRC_STAT_SELFREF_TYPE_DIS (0x0 << 4) /* SDRAM is not in Self-refresh */
|
|
#define UDDRC_STAT_SELFREF_TYPE_PHY (0x1 << 4) /* SDRAM is in Self-refresh, which was caused by PHY Master Request */
|
|
#define UDDRC_STAT_SELFREF_TYPE_SW (0x2 << 4) /* SDRAM is in Self-refresh, which was not caused solely under Automatic Self-refresh control */
|
|
#define UDDRC_STAT_SELFREF_TYPE_AUTO (0x3 << 4) /* SDRAM is in Self-refresh, which was caused by Automatic Self-refresh only */
|
|
#define UDDRC_STAT_SELFREF_TYPE_MSK (0x3 << 4) /* Self-refresh type mask */
|
|
#define UDDRC_STAT_OPMODE_INIT (0x0 << 0) /* Init */
|
|
#define UDDRC_STAT_OPMODE_NORMAL (0x1 << 0) /* Normal */
|
|
#define UDDRC_STAT_OPMODE_PWRDOWN (0x2 << 0) /* Power-down */
|
|
#define UDDRC_STAT_OPMODE_SELF_REFRESH (0x3 << 0) /* Self-refresh */
|
|
#define UDDRC_STAT_OPMODE_MSK (0x7 << 0) /* Operating mode mask */
|
|
|
|
#define UDDRC_PWRCTL (0x30) /* UDDRC Low Power Control Register */
|
|
#define UDDRC_PWRCTRL_SELFREF_SW (1 << 5) /* Software self-refresh */
|
|
|
|
#define UDDRC_DFIMISC (0x1B0) /* UDDRC DFI Miscellaneous Control Register */
|
|
#define UDDRC_DFIMISC_DFI_INIT_COMPLETE_EN (1 << 0) /* PHY initialization complete enable signal */
|
|
|
|
#define UDDRC_SWCTRL (0x320) /* UDDRC Software Register Programming Control Enable */
|
|
#define UDDRC_SWCTRL_SW_DONE (1 << 0) /* Enable quasi-dynamic register programming outside reset */
|
|
|
|
#define UDDRC_SWSTAT (0x324) /* UDDRC Software Register Programming Control Status */
|
|
#define UDDRC_SWSTAT_SW_DONE_ACK (1 << 0) /* Register programming done */
|
|
|
|
#define UDDRC_PSTAT (0x3FC) /* UDDRC Port Status Register */
|
|
#define UDDRC_PSTAT_ALL_PORTS (0x1F001F) /* Read + writes outstanding transactions on all ports */
|
|
|
|
#define UDDRC_PCTRL_0 (0x490) /* UDDRC Port 0 Control Register */
|
|
#define UDDRC_PCTRL_1 (0x540) /* UDDRC Port 1 Control Register */
|
|
#define UDDRC_PCTRL_2 (0x5F0) /* UDDRC Port 2 Control Register */
|
|
#define UDDRC_PCTRL_3 (0x6A0) /* UDDRC Port 3 Control Register */
|
|
#define UDDRC_PCTRL_4 (0x750) /* UDDRC Port 4 Control Register */
|
|
|
|
#endif /* CONFIG_SOC_SAMA7 */
|
|
|
|
#endif /* __SAMA7_DDR_H__ */
|