Vivien Didelot 70cc99d10c net: dsa: mv88e6xxx: extract FID write from ATU command ...

Not every ATU commands apply to an FID, thus remove the FID writing from
mv88e6xxx_atu_cmd and write it explicitly where needed, in order to ease
introduction of such commands.

Signed-off-by: Vivien Didelot <vivien.didelot@savoirfairelinux.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

2015-09-15 12:04:21 -07:00

..

bcm_sf2_regs.h

net: dsa: bcm_sf2: add HW bridging support

2015-02-25 17:03:38 -05:00

bcm_sf2.c

net: dsa: bcm_sf2: Fix ageing conditions and operation

2015-09-08 22:27:35 -07:00

bcm_sf2.h

net: dsa: bcm_sf2: Fix 64-bits register writes

2015-09-09 14:14:22 -07:00

Kconfig

dsa: mv88e6352/mv88e6xxx: Add support for Marvell 88E6320 and 88E6321

2015-07-09 14:34:23 -07:00

Makefile

net: dsa: Add support for Marvell 88E6352

2014-10-30 14:54:10 -04:00

mv88e6xxx.c

net: dsa: mv88e6xxx: extract FID write from ATU command

2015-09-15 12:04:21 -07:00

mv88e6xxx.h

dsa: mv88e6xxx: Set the RGMII delay based on phy interface

2015-08-31 14:48:02 -07:00

mv88e6060.c

net: dsa: Report known silicon revisions for Marvell 88E6060

2014-10-30 14:54:10 -04:00

mv88e6123_61_65.c

dsa: mv88e6xxx: Allow speed/duplex of port to be configured

2015-08-31 14:48:01 -07:00

mv88e6131.c

dsa: mv88e6xxx: Allow speed/duplex of port to be configured

2015-08-31 14:48:01 -07:00

mv88e6171.c

net: dsa: mv88e6171: add hardware 802.1Q support

2015-09-06 19:50:50 -07:00

mv88e6352.c

dsa: mv88e6xxx: Allow speed/duplex of port to be configured

2015-08-31 14:48:01 -07:00