Josh Wu 84cfbbb85a mtd: at91: atmel_nand: for PMECC, add code to check the ONFI parameter ECC requirement.
This patch will check NAND flash's ecc minimum requirement in ONFI parameter.

1. if pmecc-cap, pmecc-sector-size is set in dts. then use it. Driver will
   print out a WARNING if the values are different from ONFI parameters.
2. if pmecc-cap, pmecc-sector-size is not set in dts, then use the value
   from ONFI parameters.
    * If ONFI ECC parameters are in ONFI extended parameter page, since we are
      not support it, so assume the minimum ecc requirement is 2 bits in 512
      bytes.
    * For non-ONFI support nand flash, also assume the minimum ecc requirement is
      2 bits in 512 bytes.

Signed-off-by: Josh Wu <josh.wu@atmel.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@linux.intel.com>
2013-02-12 17:01:02 +02:00
..
2012-12-19 12:47:41 -08:00
2012-01-09 18:25:19 +00:00
2012-01-09 18:26:21 +00:00
2011-09-11 15:02:13 +03:00
2012-10-09 15:04:25 +01:00
2012-07-14 16:38:34 +04:00
2012-03-27 00:24:14 +01:00
2012-01-09 18:26:21 +00:00
2012-09-29 15:00:46 +01:00