linux/drivers/bus/mhi/core
Jeffrey Hugo 85a087df4a bus: mhi: core: Remove link_status() callback
If the MHI core detects invalid data due to a PCI read, it calls into
the controller via link_status() to double check that the link is infact
down.  All in all, this is pretty pointless, and racy.  There are no good
reasons for this, and only drawbacks.

Its pointless because chances are, the controller is going to do the same
thing to determine if the link is down - attempt a PCI access and compare
the result.  This does not make the link status decision any smarter.

Its racy because its possible that the link was down at the time of the
MHI core access, but then recovered before the controller access.  In this
case, the controller will indicate the link is not down, and the MHI core
will precede to use a bad value as the MHI core does not attempt to retry
the access.

Retrying the access in the MHI core is a bad idea because again, it is
racy - what if the link is down again?  Furthermore, there may be some
higher level state associated with the link status, that is now invalid
because the link went down.

The only reason why the MHI core could see "invalid" data when doing a PCI
access, that is actually valid, is if the register actually contained the
PCI spec defined sentinel for an invalid access.  In this case, it is
arguable that the MHI implementation broken, and should be fixed, not
worked around.

Therefore, remove the link_status() callback before anyone attempts to
implement it.

Signed-off-by: Jeffrey Hugo <jhugo@codeaurora.org>
Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Reviewed-by: Hemant Kumar <hemantk@codeaurora.org>
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Link: https://lore.kernel.org/r/20200430190555.32741-4-manivannan.sadhasivam@linaro.org
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
2020-05-05 16:58:35 +02:00
..
boot.c bus/mhi: fix printk format for size_t 2020-03-24 12:40:28 +01:00
init.c bus: mhi: core: Remove link_status() callback 2020-05-05 16:58:35 +02:00
internal.h bus: mhi: core: Add support for reading MHI info from device 2020-03-26 15:51:07 +01:00
main.c bus: mhi: core: Remove link_status() callback 2020-05-05 16:58:35 +02:00
Makefile bus: mhi: core: Add support for basic PM operations 2020-03-19 07:41:04 +01:00
pm.c bus: mhi: core: Make sure to powerdown if mhi_sync_power_up fails 2020-05-05 16:58:35 +02:00