Rob Herring 6a0e321ea7 dt-bindings: Explicitly allow additional properties in common schemas
In order to add meta-schema checks for additional/unevaluatedProperties
being present, all schema need to make this explicit. As common/shared
schema are included by other schemas, they should always allow for
additionalProperties.

Acked-by: Mark Brown <broonie@kernel.org>
Acked-by: Krzysztof Kozlowski <krzk@kernel.org>
Acked-by: Sebastian Reichel <sre@kernel.org>
Acked-by: Chanwoo Choi <cw00.choi@samsung.com>
Acked-By: Vinod Koul <vkoul@kernel.org>
Acked-by: Lee Jones <lee.jones@linaro.org>
Acked-by: Geert Uytterhoeven <geert+renesas@glider.be>
Acked-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Acked-by: Ulf Hansson <ulf.hansson@linaro.org>
Acked-by: Jonathan Cameron <Jonathan.Cameron@huawei.com>
Acked-by: Guenter Roeck <linux@roeck-us.net>
Link: https://lore.kernel.org/r/20201005183830.486085-5-robh@kernel.org
Signed-off-by: Rob Herring <robh@kernel.org>
2020-10-07 11:30:06 -05:00

52 lines
1.6 KiB
YAML

# SPDX-License-Identifier: GPL-2.0
%YAML 1.2
---
$id: http://devicetree.org/schemas/serial/rs485.yaml#
$schema: http://devicetree.org/meta-schemas/core.yaml#
title: RS485 serial communications Bindings
description: The RTS signal is capable of automatically controlling line
direction for the built-in half-duplex mode. The properties described
hereafter shall be given to a half-duplex capable UART node.
maintainers:
- Rob Herring <robh@kernel.org>
properties:
rs485-rts-delay:
description: prop-encoded-array <a b>
$ref: /schemas/types.yaml#/definitions/uint32-array
items:
items:
- description: Delay between rts signal and beginning of data sent in
milliseconds. It corresponds to the delay before sending data.
default: 0
maximum: 1000
- description: Delay between end of data sent and rts signal in milliseconds.
It corresponds to the delay after sending data and actual release
of the line.
default: 0
maximum: 1000
rs485-rts-active-low:
description: drive RTS low when sending (default is high).
$ref: /schemas/types.yaml#/definitions/flag
linux,rs485-enabled-at-boot-time:
description: enables the rs485 feature at boot time. It can be disabled
later with proper ioctl.
$ref: /schemas/types.yaml#/definitions/flag
rs485-rx-during-tx:
description: enables the receiving of data even while sending data.
$ref: /schemas/types.yaml#/definitions/flag
rs485-term-gpios:
description: GPIO pin to enable RS485 bus termination.
maxItems: 1
additionalProperties: true
...