Stefan Agner 1b5190c2e7 mmc: sdhci: do not try to use 3.3V signaling if not supported
For eMMC devices it is valid to only support 1.8V signaling. When
vqmmc is set to a fixed 1.8V regulator the stack tries to set 3.3V
initially and prints the following warning:
   mmc1: Switching to 3.3V signalling voltage failed

Clear the MMC_SIGNAL_VOLTAGE_330 flag in case 3.3V is signaling is
not available. This prevents the stack from even trying to use
3.3V signaling and avoids the above warning.

Signed-off-by: Stefan Agner <stefan@agner.ch>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>
2018-07-16 11:21:45 +02:00
..
2018-06-12 16:19:22 -07:00
2018-07-16 11:17:40 +02:00
2018-06-30 21:24:18 +09:00
2018-06-04 10:58:12 -07:00
2018-07-06 19:13:42 -07:00
2018-06-27 11:01:29 -07:00
2018-06-07 10:23:33 -07:00
2018-07-16 11:17:40 +02:00
2018-06-12 16:19:22 -07:00
2018-06-12 16:19:22 -07:00
2018-06-12 16:19:22 -07:00
2018-06-12 16:19:22 -07:00
2018-06-16 16:40:36 -07:00
2018-06-11 12:09:19 -07:00
2018-06-12 16:19:22 -07:00
2018-06-12 16:19:22 -07:00
2018-06-24 06:33:54 +08:00
2018-06-07 10:23:33 -07:00
2018-07-16 11:17:40 +02:00
2018-07-08 10:55:21 -07:00
2018-06-25 21:36:45 +08:00
2018-06-04 10:58:12 -07:00
2018-06-15 18:10:01 -03:00
2018-07-08 10:55:21 -07:00
2018-06-12 16:19:22 -07:00
2018-06-07 12:34:37 -07:00
2018-06-12 16:19:22 -07:00
2018-06-14 16:25:43 +09:00
2018-07-13 10:37:54 +02:00
2018-07-06 19:45:47 -07:00
2018-06-12 16:19:22 -07:00
2018-06-12 16:19:22 -07:00
2018-06-26 10:42:31 -07:00
2018-06-12 16:19:22 -07:00
2018-06-16 06:35:02 +09:00
2018-06-05 16:20:22 -07:00
2018-06-12 12:56:02 -07:00
2018-06-23 20:44:11 +08:00