3a85ca9d8a
Signed-off-by: Brian Austin <brian.austin@cirrus.com> Signed-off-by: Mark Brown <broonie@linaro.org>
47 lines
1.4 KiB
Plaintext
47 lines
1.4 KiB
Plaintext
CS42L52 audio CODEC
|
|
|
|
Required properties:
|
|
|
|
- compatible : "cirrus,cs42l52"
|
|
|
|
- reg : the I2C address of the device for I2C
|
|
|
|
Optional properties:
|
|
|
|
- cirrus,reset-gpio : GPIO controller's phandle and the number
|
|
of the GPIO used to reset the codec.
|
|
|
|
- cirrus,chgfreq-divisor : Values used to set the Charge Pump Frequency.
|
|
Allowable values of 0x00 through 0x0F. These are raw values written to the
|
|
register, not the actual frequency. The frequency is determined by the following.
|
|
Frequency = (64xFs)/(N+2)
|
|
N = chgfreq_val
|
|
Fs = Sample Rate (variable)
|
|
|
|
- cirrus,mica-differential-cfg : boolean, If present, then the MICA input is configured
|
|
as a differential input. If not present then the MICA input is configured as
|
|
Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input.
|
|
|
|
- cirrus,micb-differential-cfg : boolean, If present, then the MICB input is configured
|
|
as a differential input. If not present then the MICB input is configured as
|
|
Single-ended input. Single-ended mode allows for MIC1 or MIC2 muxing for input.
|
|
|
|
- cirrus,micbias-lvl: Set the output voltage level on the MICBIAS Pin
|
|
0 = 0.5 x VA
|
|
1 = 0.6 x VA
|
|
2 = 0.7 x VA
|
|
3 = 0.8 x VA
|
|
4 = 0.83 x VA
|
|
5 = 0.91 x VA
|
|
|
|
Example:
|
|
|
|
codec: codec@4a {
|
|
compatible = "cirrus,cs42l52";
|
|
reg = <0x4a>;
|
|
reset-gpio = <&gpio 10 0>;
|
|
cirrus,chgfreq-divisor = <0x05>;
|
|
cirrus.mica-differential-cfg;
|
|
cirrus,micbias-lvl = <5>;
|
|
};
|