Antoine Tenart 7a1d8390d0 net: phy: micrel: make sure the factory test bit is cleared
The KSZ8081 PHY has a factory test mode which is set at the de-assertion
of the reset line based on the RXER (KSZ8081RNA/RND) or TXC
(KSZ8081MNX/RNB) pin. If a pull-down is missing, or if the pin has a
pull-up, the factory test mode should be cleared by manually writing a 0
(according to the datasheet). This patch makes sure this factory test
bit is cleared in config_init().

Tested-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
Signed-off-by: Antoine Tenart <antoine.tenart@bootlin.com>
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: David S. Miller <davem@davemloft.net>
2019-04-29 23:17:21 -04:00
..
2019-04-15 16:48:51 -07:00
2019-03-06 09:41:12 -08:00
2019-03-16 13:05:32 -07:00
2019-02-11 09:05:58 +01:00
2019-03-29 03:04:47 +01:00
2019-03-06 14:18:59 -08:00
2019-03-15 14:37:46 -07:00
2019-04-22 11:54:47 -07:00
2019-03-10 10:17:23 -07:00
2019-03-14 09:00:06 -07:00
2019-04-20 12:52:23 -07:00
2019-03-09 14:57:08 -08:00
2019-03-06 09:41:12 -08:00
2019-03-29 15:31:16 +01:00
2019-04-10 22:45:38 -07:00
2019-03-15 14:22:59 -07:00
2019-03-11 11:22:15 -07:00
2019-04-07 06:12:10 -10:00
2019-03-10 12:29:52 -07:00