1b603f9e43
MLX4_EN depends on NETDEVICES, ETHERNET and INET Kconfigs. Make sure they are listed in MLX4_EN Kconfig dependencies. This fixes the following build break: drivers/net/ethernet/mellanox/mlx4/en_rx.c:582:18: warning: ‘struct iphdr’ declared inside parameter list [enabled by default] struct iphdr *iph) ^ drivers/net/ethernet/mellanox/mlx4/en_rx.c:582:18: warning: its scope is only this definition or declaration, which is probably not what you want [enabled by default] drivers/net/ethernet/mellanox/mlx4/en_rx.c: In function ‘get_fixed_ipv4_csum’: drivers/net/ethernet/mellanox/mlx4/en_rx.c:586:20: error: dereferencing pointer to incomplete type _u8 ipproto = iph->protocol; Signed-off-by: Saeed Mahameed <saeedm@mellanox.com> Signed-off-by: Tariq Toukan <tariqt@mellanox.com> Signed-off-by: David S. Miller <davem@davemloft.net>
49 lines
1.2 KiB
Plaintext
49 lines
1.2 KiB
Plaintext
#
|
|
# Mellanox driver configuration
|
|
#
|
|
|
|
config MLX4_EN
|
|
tristate "Mellanox Technologies 1/10/40Gbit Ethernet support"
|
|
depends on MAY_USE_DEVLINK
|
|
depends on PCI && NETDEVICES && ETHERNET && INET
|
|
select MLX4_CORE
|
|
imply PTP_1588_CLOCK
|
|
---help---
|
|
This driver supports Mellanox Technologies ConnectX Ethernet
|
|
devices.
|
|
|
|
config MLX4_EN_DCB
|
|
bool "Data Center Bridging (DCB) Support"
|
|
default y
|
|
depends on MLX4_EN && DCB
|
|
---help---
|
|
Say Y here if you want to use Data Center Bridging (DCB) in the
|
|
driver.
|
|
If set to N, will not be able to configure QoS and ratelimit attributes.
|
|
This flag is depended on the kernel's DCB support.
|
|
|
|
If unsure, set to Y
|
|
|
|
config MLX4_CORE
|
|
tristate
|
|
depends on PCI
|
|
default n
|
|
|
|
config MLX4_DEBUG
|
|
bool "Verbose debugging output" if (MLX4_CORE && EXPERT)
|
|
depends on MLX4_CORE
|
|
default y
|
|
---help---
|
|
This option causes debugging code to be compiled into the
|
|
mlx4_core driver. The output can be turned on via the
|
|
debug_level module parameter (which can also be set after
|
|
the driver is loaded through sysfs).
|
|
|
|
config MLX4_CORE_GEN2
|
|
bool "Support for old gen2 Mellanox PCI IDs" if (MLX4_CORE)
|
|
depends on MLX4_CORE
|
|
default y
|
|
---help---
|
|
Say Y here if you want to use old gen2 Mellanox devices in the
|
|
driver.
|