f0b6d3cc29
The access to the device registers is blocked during hard reset, until preboot runs and allows the access to specific registers, including the PSOC BTM_FSM register which is used to know when the reset is done. Between the reset request and until this register is polled there is a small delay of 500 msec which is not enough for F/W to process the reset and for preboot to run, so the register might be accessed while it is blocked. To avoid it, increase the delay to 2 sec. Signed-off-by: Tomer Tayar <ttayar@habana.ai> Reviewed-by: Oded Gabbay <ogabbay@kernel.org> Signed-off-by: Oded Gabbay <ogabbay@kernel.org> |
||
---|---|---|
.. | ||
altera-stapl | ||
bcm-vk | ||
c2port | ||
cardreader | ||
cb710 | ||
cxl | ||
echo | ||
eeprom | ||
genwqe | ||
habanalabs | ||
ibmasm | ||
lis3lv02d | ||
lkdtm | ||
mchp_pci1xxxx | ||
mei | ||
ocxl | ||
pvpanic | ||
sgi-gru | ||
sgi-xp | ||
ti-st | ||
uacce | ||
vmw_vmci | ||
ad525x_dpot-i2c.c | ||
ad525x_dpot-spi.c | ||
ad525x_dpot.c | ||
ad525x_dpot.h | ||
apds990x.c | ||
apds9802als.c | ||
atmel-ssc.c | ||
bh1770glc.c | ||
cs5535-mfgpt.c | ||
ds1682.c | ||
dummy-irq.c | ||
dw-xdata-pcie.c | ||
enclosure.c | ||
fastrpc.c | ||
gehc-achc.c | ||
hi6421v600-irq.c | ||
hisi_hikey_usb.c | ||
hmc6352.c | ||
hpilo.c | ||
hpilo.h | ||
ibmvmc.c | ||
ibmvmc.h | ||
ics932s401.c | ||
isl29003.c | ||
isl29020.c | ||
Kconfig | ||
kgdbts.c | ||
lattice-ecp3-config.c | ||
Makefile | ||
open-dice.c | ||
pch_phub.c | ||
pci_endpoint_test.c | ||
phantom.c | ||
qcom-coincell.c | ||
sram-exec.c | ||
sram.c | ||
sram.h | ||
tifm_7xx1.c | ||
tifm_core.c | ||
tsl2550.c | ||
vcpu_stall_detector.c | ||
vmw_balloon.c | ||
xilinx_sdfec.c |