diff --git a/.vitepress/config.mts b/.vitepress/config.mts
index d3a2ae3..2b1069d 100644
--- a/.vitepress/config.mts
+++ b/.vitepress/config.mts
@@ -196,6 +196,13 @@ export default defineConfigWithTheme({
},
},
markdown: {
+ container: {
+ tipLabel: 'TIPS',
+ warningLabel: 'WARNING',
+ dangerLabel: 'CAUTION',
+ infoLabel: 'NOTE',
+ detailsLabel: 'DETAILS'
+ },
config: (md) => {
md.use(markdownimeline);
},
diff --git a/docs/en/instalations/booting/index.md b/docs/en/instalations/booting/index.md
index 5d46e54..a9caac2 100644
--- a/docs/en/instalations/booting/index.md
+++ b/docs/en/instalations/booting/index.md
@@ -21,7 +21,9 @@ dd if=spi.installer.img of=/dev/XXX bs=1M oflag=direct,sync status=progress
- After writing the Tow-Boot image to the SD card, follow these steps:
-**Note:** If you are not sure that the battery is fully charged, it is recommended to connect the phone to a power source.
+::: info
+If you are not sure that the battery is fully charged, it is recommended to connect the phone to a power source.
+:::
### Installation process
@@ -37,7 +39,9 @@ dd if=spi.installer.img of=/dev/XXX bs=1M oflag=direct,sync status=progress
8. After a while, the screen will turn on showing a blue color or directly load into the graphical installer interface.
9. In the graphical installer interface, select "Install Tow-Boot to SPI", connect the charger to the phone, and press the "Start installation" button.
-**Note:** Erasing the storage before installation is not required. The erasing option can be used to remove Tow-Boot (or any other firmware installed in the SPI partition).
+:::info
+Erasing the storage before installation is not required. The erasing option can be used to remove Tow-Boot (or any other firmware installed in the SPI partition).
+:::
diff --git a/docs/instalations/booting/index.md b/docs/instalations/booting/index.md
index 6984bf0..8ac6929 100644
--- a/docs/instalations/booting/index.md
+++ b/docs/instalations/booting/index.md
@@ -21,8 +21,10 @@ dd if=spi.installer.img of=/dev/XXX bs=1M oflag=direct,sync status=progress
- После записи образа Tow-Boot на SD карту, выполните следующие шаги:
-**Примечание:** Если не уверены, что батарея полностью заряжена,
+::: info
+Если не уверены, что батарея полностью заряжена,
рекомендуется подключить телефон к источнику питания.
+:::
### Процесс установки
@@ -47,9 +49,11 @@ dd if=spi.installer.img of=/dev/XXX bs=1M oflag=direct,sync status=progress
SPI", подключите зарядку к телефону и нажмите кнопку "Start
installation".
-**Примечание:** Стирание хранилища перед установкой не требуется. Опция
+::: info
+Стирание хранилища перед установкой не требуется. Опция
стирания может использоваться для удаления Tow-Boot (или любого другого
прошивочного ПО, установленного в раздел SPI).
+:::