IF YOU WOULD LIKE TO GET AN ACCOUNT, please write an
email to Administrator. User accounts are meant only to access repo
and report issues and/or generate pull requests.
This is a purpose-specific Git hosting for
BaseALT
projects. Thank you for your understanding!
Только зарегистрированные пользователи имеют доступ к сервису!
Для получения аккаунта, обратитесь к администратору.
I'm not sure what 'BUG's were being encountered when the restriction
to limit lvconvert-raid.sh tests to kernels > 3.2 was added. I do know
that there were BUG's that could be triggered when testing snapshots and
some of the earliest DM RAID available in the kernel. I've taken out
the 3.2 kernel restriction and added a dm-raid >= 1.2 restriction instead.
This will allow the test to run on patched production kernels.
Separate original raid test and new raid10 test,
so the old could be tested on platforms without raid10 support.
Replace test-unfriendly `ls /dev/mapper` with dmsetup ls
When reformatting the 'lvchange_resync' code in commit
05131f5853, a '!' should have been removed
from the condition that checks for the LV_NOTSYNCED flag on a corelog
mirror LV. The presence of this '!' caused the LV_NOTSYNCED flag to be
cleared when it wasn't present and left when it was present.
It is not allowed to add images to a 'mirror' or 'raid1' LV if the
LV_NOTSYNCED flag is set. We add some up-convert tests to ensure this
behavior is being enforced and that the LV_NOTSYNCED flag is being
properly cleared by 'lvchange --resync'.
(Not updating WHATS_NEW because this is intrarelease.)
This patch adds support for RAID10. It is not the default at this
stage. The user needs to specify '--type raid10' if they would like
RAID10 instead of stacked mirror over stripe.
Indent
Shell improvements - use internal function for checks
Use PVs in "" (LV and VG cannot have spaces)
Several test very starting 'dmeventd' without annoucing
it via prepade_dmeventd.
Fix some of test actually.
When down-converting a RAID1 device, it is the last device that is extracted
and removed when the user does not specify a particular device. However,
when a device is specified (and it is not the last), the device is removed and
the remaining sub-LVs are "shifted down" to fill the hole. This cause problems
when resuming the LV because if the shifted devices were resumed (and thus
renamed) before the sub-LV being extracted, there would be a name conflict.
The solution is to resume the extracted sub-LVs first so that they can be
properly renamed preventing a possible conflict.
This addresses bug 801967.
Reduce disc excercise for some test and focus on LVM testing by
using smaller extent size.
Reduce number of teardown_devs calls and use vg/lvremove instead.
Don't sleep for seconds on pvmove.
FIXME: shell/lvconvert-mirror-basic.sh seems to need more checking.
Test fails for smalled extent size then 512k.
Failure to do so results in "Performing unsafe table load while X device(s) are
known to be suspended" errors. While fixing the problem in this way works and
is consistent with the way the mirror segment type does it, it would be nice
to find a solution that uses the generic suspend/resume calls.
Also included in this check-in are additions to the test suite that perform
conversions on RAID LVs under a snapshot. These tests are disabled for the
time being due to a kernel bug that is yet to be tracked down.
