1
0
mirror of https://github.com/systemd/systemd.git synced 2024-12-22 17:35:35 +03:00

NEWS: tweak grammar

This commit is contained in:
Zbigniew Jędrzejewski-Szmek 2013-03-26 11:56:01 -04:00
parent efc0ac6af6
commit a87197f5a2

16
NEWS
View File

@ -14,7 +14,7 @@ CHANGES WITH 199:
ExecStartPre= may now leave data in /tmp that ExecStart= of
the same service can still access). When a service is
stopped its temporary directories are immediately deleted
(normal clean-up with tmpfiles still is done in addition to
(normal clean-up with tmpfiles is still done in addition to
this though).
* By default, systemd will now set a couple of sysctl
@ -25,7 +25,7 @@ CHANGES WITH 199:
be reasonably safe, and good defaults for all new systems.
* The predictable network naming logic may now be turned off
with a new kernel command line switch: net.ifnames=0
with a new kernel command line switch: net.ifnames=0.
* A new libsystemd-bus module has been added that implements a
pretty complete D-Bus client library. For details see:
@ -33,10 +33,10 @@ CHANGES WITH 199:
http://lists.freedesktop.org/archives/systemd-devel/2013-March/009797.html
* journald will now explicitly flush the journal files to disk
the latest 5min after each write. This will also mark the
files as offline then until the next write. This should
increase reliability. The synchronization delay can be
configured via SyncIntervalSec= in journald.conf.
at the latest 5min after each write. The file will then also
be marked offline until the next write. This should increase
reliability in case of a crash. The synchronization delay
can be configured via SyncIntervalSec= in journald.conf.
* There's a new remote-fs-setup.target unit that can be used
to pull in specific services when at least one remote file
@ -50,8 +50,8 @@ CHANGES WITH 199:
* libudev gained a new call udev_device_set_attribute_value()
to set sysfs attributes of a device.
* The udev daemon now adjusts its default number of parallel
executed worker processes based on the number of available
* The udev daemon now sets the default number of worker
processes executed in parallel based on the number of available
CPUs instead of the amount of available RAM. This is supposed
to provide a more reliable default and limit a too agressive
paralellism for setups with 1000s of devices connected.