1
0
mirror of https://github.com/systemd/systemd.git synced 2024-12-23 21:35:11 +03:00
systemd/README
Kay Sievers 1e03b754ae udevd: convert to event worker processes
Event processes now get re-used after they handled an event. This reduces
pressure on the CPU significantly because cloned event processes no longer
cause page faults in the main daemon. After the events have settled, the
no longer needed worker processes get killed.
2009-06-04 01:44:04 +02:00

57 lines
2.5 KiB
Plaintext

udev - userspace device management
For more information see the files in the docs/ directory.
Important Note:
Integrating udev in the system has complex dependencies and differs from distro
to distro. All major distros depend on udev these days and the system may not
work without a properly installed version. The upstream udev project does not
recommend to replace a distro's udev installation with the upstream version.
Requirements:
- Version 2.6.25 of the Linux kernel with sysfs, procfs, signalfd, inotify,
unix domain sockets, networking and hotplug enabled.
- For reliable operation, the kernel must not use the CONFIG_SYSFS_DEPRECATED*
option.
- Unix domain sockets (CONFIG_UNIX) as a loadable kernel module is not
supported.
- The proc filesystem must be mounted on /proc/, the sysfs filesystem must
be mounted at /sys/. No other locations are supported by udev.
- The system must have the following group names resolvable at udev startup:
disk, cdrom, floppy, tape, audio, video, lp, tty, dialout, kmem.
Especially in LDAP setups, it is required, that getgrnam() is able to resolve
these group names with only the rootfs mounted, and while no network is
available.
Operation:
Udev creates and removes device nodes in /dev/, based on events the kernel
sends out on device discovery or removal.
- Early in the boot process, the /dev/ directory should get a 'tmpfs'
filesystem mounted, which is maintained by udev. Created nodes or changed
permissions will not survive a reboot, which is intentional.
- The content of /lib/udev/devices/ directory which contains the nodes,
symlinks and directories, which are always expected to be in /dev, should
be copied over to the tmpfs mounted /dev, to provide the required nodes
to initialize udev and continue booting.
- The old hotplug helper /sbin/hotplug should be disabled in the kernel
configuration, it is not needed, and may render the system unusable
because of a fork-bombing behavior.
- All kernel events are matched against a set of specified rules in
/lib/udev/rules.d/ which make it possible to hook into the event
processing to load required kernel modules and setup devices. For all
devices the kernel exports a major/minor number, udev will create a
device node with the default kernel name, or the one specified by a
matching udev rule.
Please direct any comment/question/concern to the linux-hotplug mailing list at:
linux-hotplug@vger.kernel.org