1
0
mirror of https://github.com/systemd/systemd.git synced 2024-12-25 01:34:28 +03:00
The systemd System and Service Manager
Go to file
Scott James Remnant e86a923d50 libudev: monitor - ignore messages from unusual sources
For added protection, ignore any unicast message received on the
netlink socket or any multicast message on the kernel group not
received from the kernel.

Signed-off-by: Scott James Remnant <scott@ubuntu.com>
2009-04-08 16:16:14 -07:00
docs/writing_udev_rules doc: writing udev rules - refer to 'udevadm info' instead of 'udevinfo' 2009-01-24 15:24:01 +01:00
extras usb_id: remove unused variable 2009-03-28 20:57:01 +01:00
m4 add m4/ subdir 2009-02-26 14:11:43 +01:00
rules send monitor events back to netlink socket 2009-03-29 04:24:39 +02:00
test test: add test for empty and non-existent ATTR 2009-02-05 12:40:15 +01:00
udev libudev: monitor - ignore messages from unusual sources 2009-04-08 16:16:14 -07:00
.gitignore gitignore: move *.8 to subdirs 2008-09-29 05:03:43 +02:00
autogen.sh autogen.sh: add more warnings 2009-02-05 19:01:27 +01:00
ChangeLog release 140 2009-03-13 13:17:31 +01:00
configure.ac send monitor events back to netlink socket 2009-03-29 04:24:39 +02:00
COPYING update source file headers 2006-08-28 00:29:11 +02:00
INSTALL update INSTALL 2008-08-28 22:58:03 +02:00
Makefile.am add m4/ subdir 2009-02-26 14:11:43 +01:00
Makefile.am.inc libudev: get rid of selinux 2008-10-02 18:48:40 +02:00
NEWS version bump 2009-03-18 17:54:00 +01:00
README update NEWS 2009-01-04 17:38:33 +01:00
TODO release 140 2009-03-13 13:17:31 +01:00
udev.conf udevadm: control - use getopt_long() 2008-09-03 21:56:47 +02:00

udev - userspace device management

For more information see the files in the docs/ directory.

Important Note:
  Integrating udev in the system has complex dependencies and differs from distro
  to distro. All major distros depend on udev these days and the system may not
  work without a properly installed version. The upstream udev project does not
  recommend to replace a distro's udev installation with the upstream version.

Requirements:
  - Version 2.6.22 of the Linux kernel for reliable operation of this release of
    udev. The kernel must not use the CONFIG_SYSFS_DEPRECATED* option.

  - The kernel must have sysfs, unix domain sockets and networking enabled.
    Unix domain sockets (CONFIG_UNIX) as a loadable kernel module is not
    supported.

  - The proc filesystem must be mounted on /proc/, the sysfs filesystem must
    be mounted at /sys/. No other locations are supported by udev.

  - The system must have the following group names resolvable at udev startup:
      disk, cdrom, floppy, tape, audio, video, lp, tty, dialout, kmem.
    Especially in LDAP setups, it is required, that getgrnam() is able to resolve
    these group names with only the rootfs mounted, and while no network is
    available.

Operation:
  Udev creates and removes device nodes in /dev/, based on events the kernel
  sends out on device discovery or removal.

  - Very early in the boot process, the /dev/ directory should get a 'tmpfs'
    filesystem mounted, which is populated from scratch by udev. Created nodes
    or changed permissions will not survive a reboot, which is intentional.

  - The content of /lib/udev/devices/ directory which contains the nodes,
    symlinks and directories, which are always expected to be in /dev, should
    be copied over to the tmpfs mounted /dev, to provide the required nodes
    to initialize udev and continue booting.

  - The old hotplug helper /sbin/hotplug should be disabled on bootup, before
    actions like loading kernel modules are taken, which may cause a lot of
    events.

  - The udevd daemon must be started on bootup to receive netlink uevents
    from the kernel driver core.

  - All kernel events are matched against a set of specified rules in
    /lib/udev/rules.d/ which make it possible to hook into the event
    processing to load required kernel modules and setup devices. For all
    devices the kernel exports a major/minor number, udev will create a
    device node with the default kernel name, or the one specified by a
    matching udev rule.

Please direct any comment/question/concern to the linux-hotplug mailing list at:
  linux-hotplug@vger.kernel.org