Sivaprakash Murugesan cb272395dc mtd: rawnand: qcom: set BAM mode only if not set already
BAM is DMA controller on QCOM ipq platforms, BAM mode on NAND driver
is set by writing BAM_MODE_EN bit on NAND_CTRL register.

NAND_CTRL is an operational register and in BAM mode operational
registers are read only.

So, before enabling BAM mode by writing the NAND_CTRL register, check
if BAM mode was already enabled by the bootloader, and enable BAM mode
only if it is not enabled already.

Signed-off-by: Sivaprakash Murugesan <sivaprak@codeaurora.org>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://lore.kernel.org/linux-mtd/1591948696-16015-3-git-send-email-sivaprak@codeaurora.org
2020-06-26 08:35:10 +02:00
..
2020-06-13 13:04:36 -07:00
2020-06-04 19:47:11 -07:00
2020-06-09 10:04:47 -07:00
2020-06-13 13:29:16 -07:00
2020-06-07 10:59:32 -07:00
2020-06-13 13:29:16 -07:00
2020-06-13 13:29:16 -07:00
2020-06-07 10:59:32 -07:00
2020-06-13 13:29:16 -07:00
2020-06-03 15:00:05 -07:00
2020-06-13 13:29:16 -07:00
2020-06-13 13:29:16 -07:00
2020-06-04 11:03:45 -07:00
2020-06-02 15:29:19 -07:00
2020-06-13 13:29:16 -07:00
2020-06-13 13:04:36 -07:00
2020-06-13 13:29:16 -07:00
2020-06-07 10:53:36 -07:00
2020-06-13 13:29:16 -07:00
2020-06-11 12:53:23 -07:00
2020-06-13 13:29:16 -07:00
2020-06-13 13:29:16 -07:00
2020-06-04 19:09:28 +02:00
2020-06-08 13:01:08 -07:00
2020-06-08 13:01:08 -07:00
2020-06-07 16:11:23 -07:00
2020-06-13 13:29:16 -07:00
2020-06-07 10:59:32 -07:00
2020-06-13 13:29:16 -07:00
2020-06-13 13:29:16 -07:00
2020-06-13 13:29:16 -07:00
2020-06-13 13:29:16 -07:00