Sivaprakash Murugesan cb272395dc mtd: rawnand: qcom: set BAM mode only if not set already
BAM is DMA controller on QCOM ipq platforms, BAM mode on NAND driver
is set by writing BAM_MODE_EN bit on NAND_CTRL register.

NAND_CTRL is an operational register and in BAM mode operational
registers are read only.

So, before enabling BAM mode by writing the NAND_CTRL register, check
if BAM mode was already enabled by the bootloader, and enable BAM mode
only if it is not enabled already.

Signed-off-by: Sivaprakash Murugesan <sivaprak@codeaurora.org>
Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
Link: https://lore.kernel.org/linux-mtd/1591948696-16015-3-git-send-email-sivaprak@codeaurora.org
2020-06-26 08:35:10 +02:00
..
2020-05-24 20:48:11 +02:00
2018-06-12 16:19:22 -07:00
2020-06-10 13:15:17 -07:00
2019-09-05 14:34:26 -04:00
2020-01-09 20:09:55 +01:00