IF YOU WOULD LIKE TO GET AN ACCOUNT, please write an
email to Administrator. User accounts are meant only to access repo
and report issues and/or generate pull requests.
This is a purpose-specific Git hosting for
BaseALT
projects. Thank you for your understanding!
Только зарегистрированные пользователи имеют доступ к сервису!
Для получения аккаунта, обратитесь к администратору.
Allow configuration for IPv6 discovered routes to be ignored instead of
adding them as a route. This can be used to block unwanted routes, for
example, you may wish to not receive some set of routes on an interface
if they are causing issues.
If users do not enable a service like systemd-time-wait-sync.target
(because they don't want to delay boot for external events, such as an
NTP sync), then timers should still take the the weaker time-set.target
feature into account, so that the clock is at least monotonic.
Hence, order timer units after both of the targets: time-sync.target
*and* time-set.target. That way, the right thing will happen regardless
if people have no NTP server (and thus also no
systemd-time-wait-sync.service or equivalent) or, only have an NTP
server (and no systemd-time-wait-sync.service), or have both.
Ordering after time-set.target is basically "free". The logic it is
backed by should be instant, without communication with the outside
going on. It's useful still so that time servers that implement the
timestamp from /var/ logic can run in later boot.
systemd-timesyncd.service only applies the much weaker monotonic clock
from file logic, i.e should pull in and order itself before
time-set.target. The strong time-sync.target unit is pulled in by
systemd-time-wait-sync.service.
This is similar to the base64 support, but fixed-size hash values are
typically preferably presented as series of hex values, hence store them
here like that too.
Optionally, embedd PKCS#11 token URI and encrypted key in LUKS2 JSON
metadata header. That way it becomes very easy to unlock properly set up
PKCS#11-enabled LUKS2 volumes, a simple /etc/crypttab line like the
following suffices:
mytest /dev/disk/by-partuuid/41c1df55-e628-4dbb-8492-bc69d81e172e - pkcs11-uri=auto
Such a line declares that unlocking via PKCS#11 shall be attempted, and
the token URI and the encrypted key shall be read from the LUKS2 header.
An external key file for the encrypted PKCS#11 key is hence no longer
necessary, nor is specifying the precise URI to use.